Code: A11, B21
Description: Jam at Door [A] [B] [C] [D] [E] A11: Jam at Door A B21: Jam at Duplex Unit
Remedy: 1 Ensure the correct weight and type of paper is loaded in the tray. See “Media and Tray Specifications” on page 1-16 for approved media types and weights. Go to step [2]. Load approved media and run a set of test prints through the printer. If a jam still occurs go to step [2]. 2 Check in and around the Registration Rollers, Imaging Units, Duplex Unit and Transfer Unit for any dirt, spilled toner, or debris. Remove any obstruction in the paper path. Complete Go to step [3]. 3 Verify the door reporting the error condition closes fully. Is the door damaged or warped? Replace the damaged door. Go to step [4]. 4 Clean the pick and feed rollers for the problem tray: Did this fix the problem? Go to step [5]. Replace the problem roller. 5 Inspect the paper tray and pick area to see if the paper is picked and feeds correctly from the tray. Go to step [6]. Replace the paper Tray or Feed Assembly. 6 Use service diagnostics to test the Hop and Feed sensors for the problem tray. Do the sensors function correctly? Go to step [7]. Replace the Feed Assembly. 7 Inspect the following actuators for damage and use service diagnostics to test the sensors operation: Registration Entrance Sensor Transfer Unit Entrance Sensor Do the actuators and sensors operate correctly? Go to step [10]. Replace the problem actuator For a problem sensor: Go to step [8] 8 Check the sensor for debris that could interfere with normal operation. Is there debris present? Clean the sensor or remove debris. Go to step [9]. 9 Verify the wiring harness for the problem sensor is free from damage or defects. Replace the sensor. Replace the wiring harness. 10 Use service diagnostics to test the tray feed motor and clutch. Note: Feed rollers located behind each right door are driven by the feed motor in the tray below. Example: The feed rollers behind Right Door A are driven by the tray 2 feed motor. Does the motor/clutch operate correctly? Go to step [12]. Replace the Feed Assembly for a bad clutch. For a bad motor go to step [11]. 11 Verify the wiring harness for the problem motor is free from damage or defects. Check the wiring to the LTA Controller Board for lower trays. Is the wiring free from damage or defects? Go to step [12]. Replace the Feed Assembly for the problem Tray. Replace the LTA Controller Board. 12 Use service diagnostics to test the Duplex Unit motor and clutches. Does the motor/clutch function correctly? Go to step [14]. Go to step [13]. 13 Inspect the wiring harness for the Duplex Unit. Is the wiring harness properly connected and free from defects? Replace the Duplex Unit. Replace the Engine Controller Board. 14 Use service diagnostics to test the Registration Motor and Registration Clutch. Does the motor/clutch function correctly? Go to step [16]. Go to step [15]. 15 Inspect the wiring harness for each motor and clutch. Are the wiring harnesses properly connected and free from defects? Replace the Engine Controller Board. Replace the problem wiring harness, clutch or motor. 16 Visually inspect the Registration Rollers for gaps between the rollers and ensure the grounding strap is in place properly. Is there a gap between the Registration Rollers? Replace the Registration Roller Assembly. Go to step [17]. 17 Check the connections from the Tray to the Engine Controller Board and/or LTA Controller Board. Replace the Engine Controller Board. Replace the LTA Controller Board. Replace the wiring harnesses.