Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi B8, B13 — Xerox Phaser 7300

Code: B8, B13

Description: Jam at Duplex Unit B8: Jam inside Duplex Unit. B13: Jam inside Duplex Unit.
Remedy: 1 Ensure the correct weight and type of paper is loaded in the tray. See “Media and Tray Specifications” on page 1-16 for approved media types and weights. Go to step [2]. Load approved media and run a set of test prints through the printer. If a jam still occurs go to step [2]. 2 Check for and remove any dirt, debris or obstructions in the paper path around the Duplex Unit. Did this correct the problem? Complete Go to step [3]. 3 Clean and check the Duplex Unit’s rollers. Do the rollers move freely and are free of dirt or debris? Go to step [4]. Replace the Duplex Unit. 4 Use Service Diagnostics to ensure the Duplex Unit Entrance, Middle and Exit actuators and sensors are functioning correctly. Go to step [5]. Replace the Duplex Unit. 5 Use service diagnostics to test the duplex motor and right and left duplex clutches. Do the motors and clutches function correctly? Go to step [6]. Replace the Duplex Unit. 6 Inspect the duplex unit’s wiring harness. If defective, replace the wiring harness. Is the harness properly seated and free from defects? Replace the Engine Controller Board. Replace the Duplex Unit.

← Xem tất cả mã lỗi Xerox Phaser 7300

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie