Code: E1 ... E5
Description: Misfeed at Tray [1] [2] [3] [4] [5] E1: Tray 1 E2: Tray 2 E3: Tray 3 E4: Tray 4 E5: Tray 5
Remedy: 1 Ensure the correct weight and type of paper is loaded in the tray. See “Media and Tray Specifications” on page 1-16 for approved media types and weights. Go to step [2]. Load approved media and run a set of test prints through the printer. If a jam still occurs go to step [2]. 2 Inspect the tray for damage or defects and ensure the tray is inserted and properly connected. Go to step [3]. Install or replace tray. 3 Inspect the pick and feed rollers for dirt, debris, defects or excessive wear. Clean or replace the pick rollers. Go to step [4]. 4 Use service diagnostics to test the Tray Feed Motor and feed clutch. Do the motor and clutch operate correctly? Go to step [6]. Go to step [5]. 5 Check the wiring from the Feed Motor and feed clutch to the Engine Controller Board (Tray 1) or to the LTA Controller Board (Tray 2, 3, 4, 5). Is the wiring free from damage or defects? Replace the Tray Feed Assembly or Feed Motor. Replace the wiring harness. 6 Visually inspect and use service diagnostics to check the tray hop sensor is operating correctly. Tray 1 - Replace the Engine Controller Board. Tray 2, 3, 4, 5 - Replace the LTA Controller Board. Replace the Feed Assembly.