Code: U26 ... U29
Description: [Yellow] [Magenta] [Cyan] [Black] Imaging Unit Failure U26: Yellow U27: Magenta U28: Cyan U29: Black
Remedy: 1 Is the Imaging Unit installed and seated properly? Go to step [2]. Reseat the imaging unit. 2 Visually inspect the Imaging Unit Drum Contact Assembly and springs. Are the contacts damaged or dirty? Replace the IU Drum Contact Assembly. Go to step [3]. 3 Use service diagnostics to test the CMYK IU Sensor. Does the sensor function correctly? Go to step [6} Go to step [4]. 4 Verify continuity between the IU Sensor Board and the Engine Controller Board at the JODEN connector. Y pin 9 to pin 12 M pin 1 to pin 3 C pin 5 to pin 6 K pin 10 to pin 13 Replace the Engine Controller Board. Go to step [5]. 5 Check the wiring harness. Is the wiring harness defective? Replace the wiring harness Replace the Back Plate Assembly. 6 Use service diagnostics to check the IU Up/Down motor. Is the Transfer Unit functioning properly by lifting the Imaging Unit? Go to step [11]. Go to step [7]. 7 Visually inspect the Transfer Unit gears and lifting arm. See “Transfer Unit Arm and Gear Up/Down Movement of the Imaging Units” on page 8-232. The gears should lift the arm when rotated in one direction and stop rotating. Does the gear stop rotating when the arm is in the raised position? Go to step [8]. Replace the Transfer Unit. 8 Check the appropriate fuse on the Engine Controller Board to see if it is blown. Cyan = F5 Magenta = F2 Yellow = F3 Black = F4 Go to step [10]. Go to step [9]. 9 Verify the Low Voltage Power Supply to the POWER connector on the Engine Controller Board is supplying +34 volts to pins 12, 13, and 14. Replace the Imaging Unit Motor. Replace the Low Voltage Power Supply and/or wiring harness. 10 Check the Imaging Unit wiring harness. Is the wiring harness defective? Replace the wiring harness. Replace the Engine Controller Board. 11 Inspect the Printer Unit Chassis for warping or damage. Replace the Printer Unit Chassis. Replace the Engine Controller Board.