Code: C3 ... C6
Description: Jam at Door C for Tray [3][4][5][6] Media reached the Feed-Out Sensor, but did not arrive at the Transfer Unit Entrance Sensor on time. This error represents a misfeed jam for media fed from an optional tray. Code C3: Jam at Door C for Tray 3 Code C4: Jam at Door C for Tray 4 Code C5: Jam at Door C for Tray 5 Code C6: Jam at Door C for Tray 6
Causes: • Feed Rollers • Feeder Assembly • Option Control Board • Feeder Board
Remedy: 1 Check the following for evidence of fault, dirt, debris, or damage: • Door C • Feed Rollers • Registration Rollers • Transport Rollers • Sensor Actuators Is there any damage or debris? Clean or replace the appropriate parts. Go to Step 2. 2 Check the Option connection. Is the Option connection to the Printer damaged or disconnected? Reconnect or replace the cable. Go to Step 3. 3 Check the Option Harness continuity. Disconnect OPTIF from the Engine Control Board and the Option connector. Is the harness conductive? Go to Step 4. Replace the Option harness. 4 Test the tray sensors. Run the Service Diagnostics Tray Switches test for the appropriate tray. Do the sensors function correctly? Go to Step 6. Go to Step 5. 5 Check the sensor harness continuity. Is the harness conductive? Replace the sensor. If the error persists, replace the Feeder Board. Replace the harness. 6 Test the Feeder Motors. Run the Service Diagnostics Motor tests. Do the motors function correctly? Go to step 8. Go to Step 7. 7 Check the motor harness continuity. Is the harness conductive? Replace the motor. If the error persists, Go to Step 10. Replace the harness. 8 Test the Registration Clutch. Run the Service Diagnostics Clutch test. Does the clutch function correctly? Go to step 11. Go to step 9. 9 Check the CL1 harness continuity. Is the harness conductive? Replace the clutch. If the error persists, go to Step 10. Replace the harness. 10 Check for +24 V at the Motor Driver Board’s OPTRY24 connector. 1. Close the Interlock Switches. 2. Disconnect OPTRY24. Is there +24 V at OPTRY24-1 and -2 <=> ground? Replace the affected Option Control Board. Go to Step 11. 11 Check OPTRY24 Harness continuity. Disconnect the OPTRY24 Harness. Is the OPTRY24 Harness conductive? Go to Step 13. Replace the OPTRY24 Harness. 12 Check the Registration Assembly. Is there a gap between the rollers? Replace the Registration Assembly. Go to Step 13. 13 Check the DRV1 harness continuity. Is the harness conductive? Replace the Motor Driver Board. If the error persists, replace the Engine Control Board Replace the harness.