Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi D2 — Xerox Phaser 7400

Code: D2

Description: Jam in Duplex Unit Media reached Duplex Reverse Sensor, but did not leave the Duplex Unit on time. This error represents a misfeed jam inside the Duplex Unit.
Causes: • Duplex Unit, PL16.1.0
Remedy: 1 Ensure the correct weight and type of paper is loaded in the tray. Does the media meet specifications? Go to Step 2. Run several test prints. If a jam persists, go to Step 2. 2 Check for and remove any dirt, debris or obstructions in the paper path around the Duplex Unit. Did this correct the problem? Complete Go to Step 3. 3 Clean and check the Duplex Unit rollers. Do the rollers move freely and are free of dirt or debris? Go to Step 4. Replace the Duplex Unit. 4 Test the Duplex Entrance, Reverse, Front, and Rear actuators and sensors using Service Diagnostics. Do the sensors function correctly? Go to Step 5. Replace the Duplex Unit. 5 Test the Duplex Motors. Do the motors function correctly? Go to Step 6. Replace the Duplex Unit. 6 Inspect the DUPLEX harness. If defective, replace the wiring harness. Is the harness properly seated and free from defects? Replace the Motor Driver Board. Replace the Duplex Unit.

← Xem tất cả mã lỗi Xerox Phaser 7400

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie