Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi F133 — Xerox Phaser 7400

Code: F133

Description: Finisher Punch Side Registration Sensor Failure An error was detected in the Punch Side Registration Sensor.
Causes: • Side Registration Emitter Board • Side Registration Receiver Board • Punch Control Board • Finisher Control Board
Remedy: 1 Test the Side Registration Sensor. Run the Service Diagnostics Side Registration Sensor test. Does the sensor function correctly? Go to Step 6. Go to Step 2. 2 Check the harness connection. Is P/J1007 connected to the Punch Control Board? Are P/J2010 and P/J2011 connected to the Emitter and Receiver boards? Go to Step 3. Connect the harness. 3 Check the harness continuity. Is the harness conductive? Go to Step 4. Replace the harness. 4 Check the Side Registration Sensor Emitter Board. Are the LEDs illuminated? Go to Step 5. Replace the Emitter Board. 5 Check for +5 V to the sensor. Disconnect P/J1007. Is there +5 V at J1007-9 <=> ground? Replace the Receiver Board. Replace the Punch Control Board. 6 Replace the Finisher Control Board. Does the error still occur? Replace the Engine Control Board. Complete.

← Xem tất cả mã lỗi Xerox Phaser 7400

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie