Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi F139 — Xerox Phaser 7400

Code: F139

Description: Finisher Punch Dust Sensor Failure An error was detected in the Punch Waste Sensor.
Causes: • Punch Box Sensor Emitter Board • Punch Box Sensor Receiver Board
Remedy: 1 Test the Punch Box Sensor. Run the Service Diagnostics Punch Box Set Sensor test. Does the sensor state change when the emitter is blocked? Go to Step 6. Go to Step 2. 2 Check the Punch Box Sensor Harness connection. Is P/J1005 connected to the Punch Control Board? Are P/J2005 and P/J2006 connected to the Emitter and Receiver boards? Go to Step 3. Connect the harness. 3 Check the Punch Box Sensor Harness continuity. Is the harness conductive? Go to Step 4. Replace the harness. 4 Check the Punch Box Sensor Emitter Board. Is the LED illuminated? Go to Step 5. Replace the Punch Box Emitter Board. 5 Check for +5 V to the Punch Box Sensor. Disconnect P/J2006. Is there +5 V at J2006-1 <=> J2006-2? Replace the Punch Box Sensor Receiver Board. Replace the Punch Control Board. 6 Replace the Finisher Control Board. Does the error still occur? Replace the Engine Control Board. Complete.

← Xem tất cả mã lỗi Xerox Phaser 7400

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie