Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi FN1 — Xerox Phaser 7400

Code: FN1

Description: Jam at Finisher Punch Unit Media did not clear the Finisher Entrance Sensor on time. This error represents a jam at the Finisher entrance.
Causes: • Punch Unit • Finisher Entrance Sensor • Finisher Transport Rollers
Remedy: 1 Check the following for evidence of fault or damage: • Punch Unit • Transport Rollers • Exit Rollers Are there any defects or misalignment? Replace any damaged parts. Go to Step 2. 2 Test the Finisher Entrance Sensor. Run the Service Diagnostics Finisher Entrance Sensor test. Does the sensor function correctly? Replace the Engine Control Board. Replace the sensor. If the error persists, go to Step 3. 3 Check the Entrance Sensor signal at the Finisher Control Board. Actuate the Entrance Sensor. Does the voltage across CN16-12 <=> ground change when the sensor is actuated? Replace the Finisher Control Board. Replace the harness.

← Xem tất cả mã lỗi Xerox Phaser 7400

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie