Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi FN4 — Xerox Phaser 7400

Code: FN4

Description: Jam at Finisher Upper Output Tray Media remains in the upper output path. This error represents a jam in the Finisher.
Causes: • Compiler Tray • Front and Rear Alignment Guides • Transport Rollers
Remedy: 1 Check the following for evidence of fault or damage: • Compiler Tray • Front and Rear Alignment Guides • Transport Rollers Are there any defects or misalignment? Replace any damaged parts. Go to Step 2. 2 Test the Processing Tray Sensor. Run the Service Diagnostics sensor test. Does the sensor function correctly? Replace the Engine Control Board. Replace the sensor. If the error persists, go to Step 3. 3 Check the Processing Tray Sensor signal. Actuate the sensor at the Finisher Control Board. Does the voltage across CN5-9 <=> ground change when the sensor is actuated? Replace the Finisher Control Board. Replace the harness.

← Xem tất cả mã lỗi Xerox Phaser 7400

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie