Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi FN5 — Xerox Phaser 7400

Code: FN5

Description: Jam at Finisher Saddle Stapler Media remains in the buffer area. This error represents a jam in the Finisher.
Causes: • Compiler Tray • Front and Rear Alignment Guides • Transport Rollers • Stapler
Remedy: 1 Check the following for evidence of fault or damage: • Compiler Tray • Front and Rear Alignment Guides • Transport Rollers • Stapler Are there any defects or misalignment? Replace any damaged parts. Go to Step 2. 2 Test the Folding Position Sensor. Run the Service Diagnostics Folding Position Sensor test. Do the sensor function correctly? Replace the Engine Control Board. Replace the sensor. If the error persists, go to Step 3. 3 Check the Folding Position Sensor signal at the Finisher Control Board. Actuate the sensor. Does the voltage across CN16-2 <=> ground change when the sensor is actuated? Replace the Finisher Control Board. Replace the harness.

← Xem tất cả mã lỗi Xerox Phaser 7400

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie