Code: FN8
Description: Jam at Finisher Door G Jam detected in the saddle stitch path.
Causes: • Compiler Tray • Front and Rear Alignment Guides • Transport Rollers • Stapler
Remedy: 1 Check the following for evidence of fault or damage: • Compiler Tray • Front and Rear Alignment Guides • Transport Rollers • Stapler Are there any defects or misalignment? Replace any damaged parts. Go to Step 2. 2 Test the Bind Tray Sensor. Run the Service Diagnostics sensor test. Does the sensor function correctly? Replace the Engine Control Board. Replace the sensor. If the error persists, go to Step 3. 3 Check the Processing Tray Sensor signal at the Finisher Control Board. Actuate the sensor. Does the voltage across CN15-3 <=> ground change when the sensor is actuated? Replace the Finisher Control Board. Replace the harness.