Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi FT — Xerox Phaser 7400

Code: FT

Description: Finisher Output Tray Jammed This error represents a failure of, or an obstruction in the Finisher Upper Output Tray’s up or down motion.
Causes: • Finisher Lift Motor • Lift Motor Clock Sensor • Upper or Lower Limit Sensors • Lift Belts
Remedy: 1 Check the following for evidence of fault, damage, obstruction, or debris: • Upper Output Tray • Lift belts and actuators • Limit Sensors • Shift Motor Are there any defects or misalignment? Replace any damaged parts. Go to Step 2. 2 Test the Limit Sensors. Run the Service Diagnostics Tray Upper and Lower Limit Sensor tests. Do the sensors function correctly? Go to Step 4. Replace the affected sensor. If the error persists, go to Step 3. 3 Test the sensor signals. Does the voltage change on CN15-12 (Upper) and CN-15-9 (Lower) connector of the Finisher Control Board when the sensors are actuated? Replace the Finisher Control Board. Replace the harness. 4 Test the Shift Motor. Run the Service Diagnostics Shift Motor test. Does the motor function correctly? Go to Step 4. Replace the motor. 5 Check for +24 V to the Shift Motor. Disconnect CN6 from the Finisher Control Board. Is there +24 V CN6-1 <=> CN6-2? Replace the Shift Motor. Replace the Finisher Control Board. If the error persists, go to Step 6. 6 Test the Shift Motor Clock Sensor. Run the Shift Motor Clock Sensor test. Does the sensor function correctly? Go to Step 8. Replace the sensor. 7 Test the sensor signal. Does the voltage change on CN15-5 when the sensor is actuated? Replace the Finisher Control Board. Replace the wiring. If the error persists, replace the Engine Control Board.

← Xem tất cả mã lỗi Xerox Phaser 7400

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie