Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi T3 ... T8 — Xerox Phaser 7400

Code: T3 ... T8

Description: Fuser Thermistor Errors Code T3: Fuser Belt Thermistor Short Circuit Code T4: Fuser Belt Thermistor Open Circuit Code T5: Fuser Belt Thermistor Temperature too High Code T6: Fuser Belt Thermistor Temperature too Low Code T7: Fuser Release Error Code T8: Fuser Belt Slack Error
Causes: • Fuser, PL1.1.21 • Engine Control Board, PL1.1.4
Remedy: 1 Check the Fuser for damage. Is the Fuser connector damaged? Replace the Fuser. Go to Step 2. 2 Check all pins on the FSRSNR Harness for continuity. Disconnect the FSRSNR Harness from the Engine Control Board HEATIF connector and Fuser connector. Is the harness conductive? Go to Step 6. Replace the FSRSNR Harness. 3 Check all pins on the FSRPWR Harness for continuity. Disconnect CN4 on the LVPS. Is the harness conductive? Replace the LVPS. If the error persists, replace the Engine Control Board. Replace the FSRPWR Harness.

← Xem tất cả mã lỗi Xerox Phaser 7400

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie