Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi TC1 — Xerox Phaser 7400

Code: TC1

Description: Jam Under Imaging Units Paper transport jam on Transfer Unit belt. Media reached the Transfer Unit Entrance Sensor, but did not reach the Media Slack Sensor on time.
Causes: • Transfer Unit Motor, PL2.1.86 • Transfer Unit, PL1.1.20 • Media Slack Sensor, PL9.1.77 • Registration Sensor Board, PL9.1.73 • Imaging Units, PL1.1.23
Remedy: 1 Check the following for evidence of fault or damage: • Transfer Unit • Media Slack Sensor Actuator • Transfer Unit Motor Is there any damage or debris? Replace any damaged parts. Go to Step 2. 2 Test the Media Slack Sensor. Run the Service Diagnostics Paper Slack test. Does the sensor function correctly? Go to Step 7. Replace the sensor. If the error persists, go to Step 3. 3 Check all pins on the DSNS Harness for continuity. Is the harness conductive? Go to Step 4. Replace the DSNS Harness. 4 Check for +5 V to the Media Slack Sensor. Disconnect DSNS from the Registration Sensor Board. Is there +5 V across DSNS-9 <=> ground? Go to Step 6. Go to Step 5. 5 Check for +5 V to the Registration Sensor Board. Disconnect the harness from CSNS on the Engine Control Board. Is there +5 V across CSNS-14 <=> ground? Go to Step 6. Replace the Engine Control Board. 6 Check all pins on the CSNS Harness for continuity Is the harness conductive? Replace the Registration Sensor Board. Replace the harness. 7 Test the Transfer Unit Motor. Run the Service Diagnostics Transfer Belt Motor test. Does the motor function correctly? Replace the Transfer Unit. Replace the motor.

← Xem tất cả mã lỗi Xerox Phaser 7400

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie