Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi U26 ... U29 — Xerox Phaser 7400

Code: U26 ... U29

Description: [C][M][Y][K] Imaging Unit Failure The Drum Phase Sensor for the named Imaging Unit indicates that the drum is out of position. Code U26: Yellow Imaging Unit Failure Code U27: Magenta Imaging Unit Failure Code U28: Cyan Imaging Unit Failure Code U29: Black Imaging Unit Failure
Causes: • [C][M][Y][K] Imaging Unit, PL1.1.23 • [C][M][Y][K] I/U Motor, PL2.1.8 • I/U Sensor Board, PL5.1.21 • I/U Lift Uplink, PL6.1.4, PL5.1.11
Remedy: 1 Check the following for evidence of fault or damage: • Imaging Unit • Imaging Unit Drive Gears • Imaging Unit Sensor Board • Imaging Unit Lift Uplink Is there any damage? Replace any damaged parts. Go to Step 2. 2 Test the Drum Phase Sensor. Run the Service Diagnostics Drum Phase Sensor test for the indicated Imaging Unit. Does the sensor function correctly? Go to Step 5 Go to Step 3. 3 Check the I/U Phase signal: CIDPHASE at CTG1-18 MIDPHASE at CTG1-20 YIDPHASE at CTG1-22 KIDPHASE at CTG1-24 Does the Drum Phase signal change when the sensor is blocked? Go to Step 4. Replace the I/U Sensor Board. 4 Check the CTG0 harness continuity. Disconnect CTG1 from the Imaging Unit Sensor Board and CTG0 from the Engine Control Board. Is the harness conductive? Replace the Engine Control Board. Replace the harness. 5 Test the indicated Imaging Unit Motor. 1. Remove the affected Imaging Unit. 2. Close the Interlock Switches. 3. Run the Service Diagnostics Imaging Unit Motor test for the affected motor. Does the motor function correctly? Go to Step 6. Replace the motor. If the error persists, go to Step 6. 6 Check the Lift Uplink and associated gears. See "Imaging Unit Drive Motors" on page 2-39 for a description of Lift Uplink operation. 1. Access the Cyan Imaging Unit Motor. 2. Rotate the Cyan Motor manually in both directions. Do the gears and links function properly? Replace the Cyan Imaging Unit Motor. If the error persists, go to Step 7. Replace the Lift Uplink. 7 Check for +24 V at the Motor Driver Board POW24 connector. Is there +24 V at POW24-1 Replace the Motor Driver Board. Replace the LVPS and/ or POW24 harness.

← Xem tất cả mã lỗi Xerox Phaser 7400

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie