Code: U32
Description: Fuser Fan Failure The Fuser Fan rotation signal indicates that the fan is no longer operational.
Causes: • Fuser Fan, PL2.1.111 • IDFAN harness, PL5.1.31 • Engine Control Board, PL1.1.4
Remedy: 1 Check the following for evidence of fault or damage: • Fuser Fan • P/J250 • FSRFAN Harness Is there any damage? Replace any damaged parts. Go to Step 2. 2 Check the Fan connection. Is P/J250 on the printer frame securely connected? Go to Step 3. Connect the Fan. 3 Check for +24 V at the Fan connector. Disconnect the P/J250. Is there +24 V between J250-1 <=> ground? Replace the Fuser Fan. Go to Step 4. 4 Check for +24 V at the IDFAN connector. Disconnect IDFAN from the Imaging Unit Sensor Board. Is there +24 V between IDFAN-7 <=> ground? Go to Step 5. Go to Step 6. 5 Check continuity of the FSRFAN Harness. Disconnect IDFAN and P/J250. Is the wiring harness conductive? Replace the Fuser Fan. Replace the harness. 6 Check continuity of the CTG1 Harness. Is the wiring harness conductive? Replace the Engine Control Board Replace the harness.