Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi U60 — Xerox Phaser 7400

Code: U60

Description: Job Offset Home Position Error Applicable Status Code: Code U60: Job Offset Home Position Sensor does not detect home position for the Job Offset Assembly.
Causes: • Offset Home Position Sensor, PL11.1.32 • Rear Sensor Board, PL11.1.33 • Job Offset Assembly, PL13.1.1
Remedy: 1 Check the following for evidence of fault or damage: • Home Position Sensor Actuator • Home Position Sensor • SNS Harness Is there any damage or misalignment? Replace any damaged parts. Go to Step 2. 2 Test the Job Offset Home Position Sensor. Run the Service Diagnostics Offset Home Position test. Does the sensor function correctly? Replace the Engine Control Board. Go to Step 3. 3 Replace the Job Offset Home Position Sensor. Does the error persist? Go to Step 4. Complete. 4 Check the SNS connection. Is SNS connected to the Rear Sensor Board? Go to Step 5. Reconnect the harness. 5 Check for +5V to the sensor. Disconnect P/J150. Is there +5 V at J150-1? Go to Step 6. Replace the Rear Sensor Board. 6 Check the SNS Harness for continuity. 1. Disconnect SNS and P/J150. 2. Check continuity between SNS <=>J150. Go to Step 7. Replace the SNS Harness. 7 Check the Job Offset Home Position signal. Does the voltage change at RSNS-10 when the sensor is actuated? Go to Step 8. Replace the Rear Sensor Board. 8 Check all pins on the RSNS Harness for continuity. Is the harness conductive? Replace the Engine Control Board. Replace the RSNS Harness.

← Xem tất cả mã lỗi Xerox Phaser 7400

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie