Code: 11
Description: 06-372 ERROR 11 LASER UNIT POLYGON MOTOR FAILURE Note If this failure reoccurs three times successively, an Engine NVRAM value is set preventing further printer use until the Clear Tech Rep Fault, Clear <09-380 ~ 09-383> is run.
Remedy: Remove Rear Cover. Disconnect P400 and P401 on the Engine Control Board. Inspect both connectors to determine they are fully engaged as a unit. Re-engage, if necessary. Note The two connectors can NOT properly seat into their socket(s) unless they are both engaged as a unit. Ensure there is no separation. Carefully reinsert the plugs into their joint socket and FIRMLY seat them. Replace the Laser Unit. Note Whenever the mounting screws for the Laser Unit have been loosened, it is necessary to recalibrate the unit by performing the RegiCon Adjustment Procedure beginning.