Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 111, 112 — Xerox Phaser 7700

Code: 111, 112

Description: 12-241 12-242 FINISHER ERROR 111 STAPLER MOVE SENSOR ON FAILURE FINISHER ERROR 112 STAPLER MOVE SENSOR OFF FAILURE
Remedy: Open the Finisher Front Door. Defeat the Front Door Interlock Switch. Enter Service Diagnostics Mode. Run the Stapler “Move Front, Move Rear” and “Reverse” tests to verify the movement of the Stapler Carriage Assembly. Does the Stapler Carriage Assembly move smoothly through its full range of travel? Y↓N→ Refer to the Finisher Troubleshooting Procedures to troubleshoot this problem. Inspect the Stapler Move Sensor for damage and secure mounting. Is the sensor in good condition and secure? Y↓N→ Repair or replace the sensor. Remove the Finisher Rear Cover and the Board Cover. Measure the voltage between Finisher Board connector P852-7 and Finisher frame ground while interrupting the Move Sensor. Does the voltage toggle between 0 VDC and +5 VDC? Y↓N→ Measure the voltage at Finisher Board connector P852-8. Does the voltage measure +5 VDC? Y↓N→ Replace the Finisher Control Board. Measure the voltage at Finisher Board connector P852-6. Does the voltage measure 0 VDC? Y↓N→ Replace the Finisher Control Board. Replace the Move Sensor. Replace the Finisher Control Board. If the problem persists, replace Printer Engine Control Board. If the problem continues to persist, verify the ground continuity between Finisher frame ground and Printer frame ground.

← Xem tất cả mã lỗi Xerox Phaser 7700

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie