Code: 113
Description: 12-244 FINISHER ERROR 113 STAPLER FAILURE
Remedy: Open the Finisher Front Door. Verify the Stapler Carriage is its full home position. Enter Service Diagnostics Mode. Run the Stapler “Head Home” sensor test to verify home position. Does the sensor indicate home position? Y↓N→ Remove the Finisher Rear Cover and the Board Cover. Measure the voltage between Finisher Board connector P852-2 and Finisher frame ground while interrupting the Home Sensor. Does the voltage toggle between 0 VDC and +5 VDC? Y↓N→ Measure the voltage between Finisher Board connector P852-1 and Finisher frame ground. Does the voltage measure +5 VDC? Y↓N→ Disconnect to the Stapler Unit Assembly. Measure again the voltage between Finisher Board connector P852-1 and Finisher frame ground. Does the voltage now measure +5 VDC? Y↓N→ Replace the Finisher Control Board. Replace the Stapler Unit Assembly. Measure the voltage between Finisher Board connector P852-5 and Finisher frame ground. Does the voltage measure 0 VDC? Y↓N→ Test the wiring harness and the Finisher Control Board for continuity to Finisher frame ground. Replace the Finisher Control Board. Replace the Stapler Unit Assembly. Replace the Finisher Control Board. Perform the Stapler “Ready” sensor test. Does the sensor indicate the Stapler is ready? Y↓N→ Remove the Finisher Front Cover. Measure the voltage between Stapler Unit Assembly connector J886-3 and Finisher frame ground. Does the voltage measure 0 VDC? Y↓N→ Replace the Stapler Unit Assembly. Remove the Finisher Rear Cover and the Board Cover. Measure the voltage between Finisher Board connector P852-3 and Finisher frame ground. Does the voltage measure 0 VDC? Y↓N→ Repair or replace the wiring between the Stapler Unit Assembly and the Finisher Control Board. Replace the Finisher Control Board. Replace the Finisher Control Board. If the problem persists, replace printer Engine Control Board. If the problem continues to persist, verify the ground continuity between Finisher frame ground and Printer frame ground.