Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 116 — Xerox Phaser 7700

Code: 116

Description: 12-254 FINISHER ERROR 116 STACKER HEIGHT SENSOR OFF FAILURE
Remedy: Is the Finisher Stacker Tray installed? Y↓N→ Install Finisher Stacker Tray. Switch printer power Off, then On. Inspect the Stack Height Sensor Actuator for proper installation or damage. Is the Stack Height Sensor Actuator installed correctly and in good condition? Y↓N→ Reinstall or replace the Stack Height Sensor Actuator. Switch printer power OFF, then ON. Enter Service Diagnostics Mode. From the Main Menu, select “Stacker Tests/Finisher Sensors/Stacker.” Remove the two screws holding the access door halves together. Manually operate the Stacker Height Sensor by moving the actuator. Does the display indicate the Stack Height Sensor toggling between H & L? Y↓N→ Remove the Rear Cover and the Board Cover. Measure the voltage between the Finisher Control Board P850B-5 and Finisher frame ground. Again manually actuate the Stack Height Sensor. Does the voltage toggle between +5 VDC and 0 VDC? Y↓N→ Measure the voltage at the Stack Height Sensor pin 2 (yellow) and Finisher frame ground. Once again manually actuate the Stack Height Sensor. Does the voltage toggle between +5 VDC and 0 VDC? Y↓N→ Measure the voltage at Stack Height Sensor pin 1 (gray). Does the voltage measure +5 VDC? Y↓N→ Measure the voltage between the Finisher Control Board P850B-6 and Finisher frame ground. Does the voltage measure +5 VDC? Y↓N→ Replace the Finisher Control Board. Repair or replace the wiring harness between the Finisher Control Board and the Stack Height Sensor. NoteThere is an intermediate connector in this harness (J870) behind the Front Cover. Remove Front Door to repair/replace the harness. Measure the voltage at the Stack Height Sensor pin 3 (violet) and Finisher frame ground. Does the voltage measure 0 VDC? Y↓N→ Measure the voltage between the Finisher Control Board P850B-4 and Finisher frame ground. Does the voltage measure 0 VDC? Y↓N→ Replace the Finisher Control Board. Note There is an intermediate connector in this harness (J870) behind the Front Cover. Remove Front Door to repair/replace the harness. Repair or replace the wiring harness between the Finisher Control Board and the Stack Height Sensor Replace the Stack Height Sensor. Repair or replace the wiring harness between the Finisher Control Board and the Stack Height Sensor. Note There is an intermediate connector in this harness (J870) behind the Front Cover. Remove Front Door to repair/replace the harness. Replace the Finisher Control Board. Replace the Finisher Control Board.

← Xem tất cả mã lỗi Xerox Phaser 7700

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie