Code: 12
Description: 09-380 ERROR 12 YELLOW ATC SENSOR FAILURE
Remedy: Note If this failure reoccurs three times successively, an Engine NVRAM value is set preventing further printer use until the NVRAM Access / Clear Tech Rep Fault / Clear <09-380 ~ 09-383> is run. Note If necessary, enter Service Diagnostics Mode and run the “Clear Tech Rep Fault” procedure. Remove the Rear Cover and Rear Shield. Measure the voltage at P534-2 on the Engine Control Board. Does the voltage measure between +1 VDC and +3 VDC? Y↓N→ Measure the voltage at P534-3 on the Engine Control Board. Does the voltage measure +5 VDC? Y↓N→ Replace the Engine Control Board. Remove the Rear Cover and Rear Shield. Measure the voltage at P534-1 on the Engine Control Board. Does the voltage measure 0 VDC? Y↓N→ Replace the Engine Control Board. Remove the Print Cartridge Plate Cover. Inspect the wiring harness between the Engine Control Board and the Developer Housing Assembly. Is the wiring harness in good condition? Y↓N→ Repair or replace as necessary. Replace the Developer Housing Assembly. Replace the Engine Control Board. Note Run approximately 10 pages of solid fill full-page prints of this primary color to ensure this error is cleared.