Code: 33
Description: 09-350 ERROR 33 UNEXPECTED Accumulator Belt HOME SENSOR SIGNAL
Remedy: Remove the Accumulator Belt Assembly. Inspect the connector for damage. Is the connector in good condition? Y↓N→ Replace the Accumulator Belt Assembly. Inspect the mating connector inside the printer for corresponding damage. Repair or replace the harness between the Accumulator Belt and connector J605. Reinstall the Accumulator Belt Assembly. Switch printer power ON. Remove the Rear Cover. Remove the Rear Shield. Measure the voltage between the Engine Control Interface Board P533A-6(+) and frame ground. Does the voltage measure between +1 VDC and 3 VDC? Y↓N→ Measure the voltage between the Engine Control Interface Board P533A-7(+) and frame ground. Does the voltage measure +5 VDC? Y↓N→ Replace the Engine Control Board. If the problem persists, replace the Engine Control Interface Board. Measure the voltage between the Engine Control Interface Board P533A-5(+)and frame ground. Does the voltage measure 0 VDC? Y↓N→ Replace the Engine Control Board. If the problem persists, replace the Engine Control Interface Board. Replace the Accumulator Belt Assembly. If the problem persists, repair or replace the wiring harness between the Engine Interface Board and the Accumulator Belt Assembly. If the problem persists, replace the Engine Control Board. If the problem persists, replace the Engine Control Interface Board.