Code: 78
Description: 09-358 ERROR 78 WASTE TONER CARTRIDGE FULL DETECTION SENSOR FAILURE
Remedy: Remove the Waste Cartridge Sensor Holder without disconnecting the harnesses. Measure the voltage between the yellow wire to the Waste Cartridge Full Sensor and frame ground and alternately interrupt the Waste Cartridge Full Sensor. Does the voltage toggle between +5 VDC and 0 VDC? Y↓N→ Measure the voltage between the gray wire to the Waste Cartridge Full Sensor and frame ground. Does the voltage measure +5 VDC? Y↓N→ Remove the Rear Cover and Rear Shield. Measure the voltage at P406A-3 on the Engine Control Board. Does the voltage measure +5 VDC? Y↓N→ Replace the Engine Control Board. Inspect the wiring harness between the Engine Board and the Waste Cartridge Full Sensor. Repair or replace the harness as necessary. Measure the voltage between the violet wire to the Waste Cartridge Full Sensor and frame ground. Does the voltage measure 0 VDC? Y↓N→ Inspect the wiring harness between the Engine Board and the Waste Cartridge Full Sensor. Repair or replace the harness as necessary. Replace the Waste Cartridge Full Sensor. Remove the Rear Cover and Rear Shield. Measure the voltage at P406A-2 (Voltage Measurements) on the Engine Control Board. Alternately interrupt the Waste Cartridge Full Sensor again. Does the voltage toggle between +5 VDC and 0 VDC? Y↓N→ Inspect the wiring harness between the Engine Board and the Waste Cartridge Full Sensor. Repair or replace the harness as necessary. Replace the Engine Control Board.