Code: 10, 11
Description: Laser Unit Failure, Code 10 Laser Unit Polygon Motor Failure, Code 11 Note If this failure reoccurs three times successively, an Engine NVRAM value is set preventing further printer use until the Clear Tech Rep Fault is performed.
Causes: • Laser Assembly • Engine Control Board
Remedy: 1. Remove the rear cover from the printer. 2. Disconnect P401 and P402 from the Engine Control Board. 3. Carefully reinsert the plugs into their joint socket and FIRMLY seat them. 4. Did this fix the problem? Complete. Replace the laser unit. (You must perform the RegiCon Adjustment after replacing the laser unit.) If the problem persists, replace the engine control board.