Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 118, 119 — Xerox Phaser 7750

Code: 118, 119

Description: Finisher Stapler Front Corner On Failure, Code 118 Finisher Stapler Front Corner Off Failure, Code 119 Error Code 118: The Staple Front Corner Sensor did not turn ON within 2 seconds after the system started to move to the Front Corner. Or the Staple Front Corner Sensor remained ON when starting the move to the Front Corner. Error Code 119: The Staple Front Corner Sensor did not turn OFF within 2 seconds after starting to move from the Front Corner. Or the Staple Front Corner Sensor does not turn OFF after the move from the Front Corner was completed.
Causes: • Finisher Control Board • Staple Move Motor
Remedy: 1 1. Manually move the staple head. 2. Does the head move smoothly from front to rear? Go to step 2. Diagnose and repair the mechanical defect. 2 1. Check the Stapler Front Corner Sensor in diagnostics. 2. Does the value change from L to H? Go to step 5. Use the transmissive Sensor procedure to diagnose and repair the sensor. 3 1. Defeat the front door interlock switch then run the Stapler: Move Front or Move Rear motor test in diagnostics. 2. Does the stapler move motor run? Replace the finisher control board. Go to step 4. 4 Is +24 VDC present at P847-4? Replace the stapler move motor. Go to step 5. 5 Is +24 VDC present at test point 9 on the finisher control board? Replace the finisher control board. Troubleshoot and repair the +24 VDC interlock circuit.

← Xem tất cả mã lỗi Xerox Phaser 7750

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie