Code: 12, 13, 14
Description: Yellow ATC Sensor Failure, Code 12 Magenta ATC Sensor Failure, Code 13 Cyan ATC Sensor Failure, Code 14 The ATC Sensor detects an insufficient amount of developer. Note If this failure reoccurs three times successively, an Engine NVRAM value is set preventing further printer use until the Clear Tech Rep Fault is performed.
Causes: • ATC Sensor and Harness • Engine Control Board
Remedy: 1 Is the problem toner and/or developer empty. Replace the toner or developer. Go to step 2. 2 Is the ATC sensor clean and free of dust, toner or any other contaminates? Go to step 3. Clean the ATC sensor. 3 1. Check the ATC sensor wiring harness Yellow = P/J129 Magenta = P/J 130 Cyan = P/J 131 2. Is the wiring harness or the sensor defective? Replace the ATC Sensor and/or wiring harness. Go to step 4. 4 1. Remove the Rear Cover and Rear Shield. 2. Measure the voltage at... Yellow = P405B3 Magenta = P405B8 Cyan = P405A10 on the engine control board. 3. Is the voltage between +1 and +3 VDC? Replace the engine control board. Go to step 5. 5 1. Measure the voltage at... Yellow = P405B14 Magenta = P405B11 Cyan = P405A11 on the engine control board. 2. Is the voltage +5 VDC? Replace the engine control board. Go to step 6. 6 1. Measure the voltage at... Yellow = P405B2 Magenta = P405B9 Cyan = P405A9 on the engine control board. 2. Is the voltage 0 VDC? Replace the engine control board. Go to step 7. 7 1. Remove the Imaging Unit Plate cover. 2. Inspect the wiring harness between the engine control board and the developer housing assembly. 3. Is the wiring harness defective? Replace the wiring harness. Replace the ATC Sensor. 8 Run approximately 10 pages of the solid fill full-page prints for this color to ensure the error is cleared.