Code: 120, 121
Description: Finisher Eject Clamp Home Sensor On Failure, Code 120 Finisher Eject Clamp Home Sensor Off Failure, Code 121
Causes: • Eject Motor • Finisher Control Board
Remedy: 1 1. Remove the Set Clamp Home Sensor Bracket from the Finisher while leaving the connector plugged in. 2. Check the Set Clamp home sensor in diagnostics. 3. Does the value change from H to L while blocking and unblocking the sensor? Go to step 2. Use the transmissive Sensor procedure to diagnose and repair the sensor. 2 1. Reinstall the sensor in the Finisher. And turn the printer on. 2. Is the eject clamp up? Replace the finisher control board. Go to step 3. 3 1. Run the Eject Release Test in diagnostics. 2. Does the Eject Motor Run? Diagnose and repair the mechanical problem with the eject clamp assembly. Go to step 4. 4 1. Is +24 VDC present at P846-12? Replace the eject motor. Go to step 5. 5 1. Is +24 VDC present at test point 9 on the finisher control board? Replace the finisher control board. Troubleshoot and repair the +24 VDC interlock circuit.