Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 15 — Xerox Phaser 7750

Code: 15

Description: Black ATC Sensor Failure, Code 15 The ATC Sensor detects an insufficient amount of developer. Note If this failure reoccurs three times successively, an Engine NVRAM value is set preventing further printer use until the Clear Tech Rep Fault is performed. If this error is intermittant, replace the black developer clutch.
Causes: • ATC Sensor and Harness • Engine Control Board
Remedy: 1 Is the black toner and/or developer empty? Replace the toner or developer. Go to step 2. 2 Is the ATC sensor clean and free of dust, toner or any other contaminates? Go to step 3. Clean the ATC sensor. 3 1. Check the ATC sensor wiring harness (P/J132). 2. Is the wiring harness or the sensor defective? Replace the ATC Sensor and/or wiring harness. Go to step 4. 4 1. Remove the rear cover and rear shield. 2. Measure the voltage at P405A3 on the engine control board. 3. Is the voltage between +1 and +3 VDC? Go to step 5. Replace the engine control board. 5 1. Measure the voltage at P405A4 on the engine control board. 2. Is the voltage +5 VDC? Go to step 6. Replace the engine control board. 6 1. Measure the voltage at P405A2 on the engine control board. 2. Is the voltage 0 VDC? Go to step 7. Replace the engine control board. 7 1. Remove the imaging unit plate cover. 2. Inspect the wiring harness between the engine control board and the developer housing assembly. 3. Is the wiring harness defective? Replace the wiring harness. Replace the ATC sensor. 8 Run approximately 10 pages of the solid fill full-page prints for this color to ensure the error is cleared.

← Xem tất cả mã lỗi Xerox Phaser 7750

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie