Code: 32, 34
Description: Accumulator Belt Edge Sensor Failure, Code 32 Accumulator Belt Drive Logic Failure, Code 34
Causes: • Accumulator Belt Assembly • Engine Interface Board • Engine Control Board
Remedy: 1 1. Remove the accumulator belt assembly. 2. Inspect the connector for damage. 3. Is the connector damaged? Replace the accumulator belt assembly. Go to step 2. 2 Is the edge sensor actuator touching the belt? Replace the accumulator belt assembly. Go to step 3. 3 1. Is the mating connector inside the printer damaged? Repair or replace the wiring harness between the connector and J605. Go to step 4. 4 1. Reinstall the accumulator belt assembly. 2. Enter service diagnostics and run the Belt Edge Sensor test. 3. Is the result OK? Go to step 5. Run the Belt Edge Learn and recheck. If it still fails go to step 8. 5 1. Switch printer power ON. 2. Remove the rear cover and shield. 3. Measure the voltage between the engine control interface board and J533A11(+) and frame ground. 4. Does the voltage measure between +1 to +3 VDC? Go to step 8. Go to step 6. 6 1. Measure the voltage between the engine control interface board and J533A-9 and frame ground. 2. Does the voltage measure +5 VDC? Go to step 7. Replace in the following order: • engine control interface board • engine control board 7 1. Measure the voltage between the engine control interface board and J533A-10 and frame ground. 2. Does the voltage measure +5 VDC? Replace in the following order: • engine control interface board • engine control board The edge sensor is defective, replace the accumulator belt assembly. 8 1. Remove the accumulator belt assembly. 2. Enter service diagnostics and run the Steering Motor test. 3. Does the motor turn? Replace the accumulator belt assembly. If the problem is unresolved replace the engine control board. Go to step 9. 9 1. Measure the voltage between the engine control interface board J550-5 and frame ground. 2. Is the voltage +24 VDC? Go to step 10. Replace in the following order: • engine control interface board • engine control board 10 1. Measure the voltage between the engine control interface board J550 Pins 1, 2, 3, 4 and frame ground. 2. Is the voltage +24 VDC? Replace in the following order: • engine control interface board • engine control board Replace the steering drive assembly.