Code: 33
Description: Unexpected Accumulator Belt Home Sensor Signal, Code 33
Causes: • Accumulator Belt Assembly • Engine Control Interface Board • Engine Control Board
Remedy: 1 1. Remove the accumulator belt assembly. 2. Inspect the DTS connector for damage. 3. Is the connector damaged? Replace the accumulator belt assembly. Go to step 2. 2 1. Is the mating connector inside the printer damaged? Repair or replace the wiring harness between J605 and the connector. Go to step 3. 3 1. Reinstall the accumulator belt assembly. 2. Enter service diagnostics and run the Accum MOB Sensor test. 3. Is the value H when the belt home marker is NOT under the belt home sensor? Use the "Reflective Sensor Procedure". Replace in the following order: • engine control interface board • engine control board