Code: 46, 47
Description: Fuser STS (Rear) Warm Time Failure, Code 46 Sub-heater warm-up error. The temperature did not reach “Ready” temperature within the specified time. Fuser SSR2 On Time Failure, Code 47 The Sub-heater remained ON for more than the specified time.
Causes: • Fuser • Engine Control Board
Remedy: 1 1. Turn OFF power, remove the fuser assembly and allow it to cool down. 2. Measure the resistance between the Fuser connector P600-7 and P600-9. 3. Does the resistance measure between 30 K and 190 K Ohms? Go to step 2. Replace the fuser assembly. 2 1. Measure the resistance between fuser connector P600-3 and P600-12. 2. Does the resistance measure 20 Ohms or less? Go to step 3. Replace the fuser assembly. 3 1. Reinstall the fuser assembly. 2. Enter service diagnostics. 3. From the Sensor Tests run the Fuser Temperature test. 4. Is the temperature indicated approximately 165o C? Go to step 5. Go to step 4. 4 1. Turn printer power OFF. 2. Check for an open circuit or poor connection between J641-4 and J641-5. 3. Is the wiring harness OK? Replace the engine control board. Repair or replace the wiring harness. 5 1. Is line voltage present at FS47 on the AC drive board? Go to step 6. Go to step 7. 6 1. Check the wiring harness between FS47 and J600-1 for an open circuit or poor connection. 2. Is the wiring harness OK? Replace the fuser assembly. Replace the AC power chassis assembly. 7 1. Check for +5 VDC at P/J 590-3 on the AC drive board. Go to step 8. Replace the engine control board. 8 1. Check for +24 VDC at P/J 590-1 on the AC drive board. Replace the AC power chassis assembly. Replace the fuser assembly.