Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 001-300 — Xerox Phaser 7760

Code: 001-300

Description: Left Cover (Door A) Open Left Cover (Door A) is open.
Remedy: Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK.. Open and close Left Cover (PL 2.7). The display changes. Y↓N→Measure the voltage between +24 LVPS J172B and GND(-). +24 VDC measured. Y↓N→Check for +5 VDC between the gray and violet wires at P511 on the printer +5 VDC LVPS (PL 9.1). +5 VDC is measured. Y↓N→Go to, +5 VDC Low-Voltage Power Supplies RAP. Replace the LVPS (PL 9.1). Remove the Rear Cover. Disconnect J172B (from Left Cover Interlock Switch (PL 2.10)). Check resistance between A1 and B1 when switch is actuated. Resistance is less than 3 ohms. Y↓N→Replace the Left Cover Interlock Switch (PL 2.10). Reinstall the Switch. Close the Left Cover (PL 2.7). Measure the voltage at J531-5 on the I/F PWB. +24 VDC measured. Y↓N→Repair the open circuit between the +24 VDC LVPS and the I/F PWB. Replace the Interface PWB (PL 9.1). If the problem continues, replace the Engine Control Board (MCU PWB) (PL 13.1). Check installation of the Cover/Actuator.

← Xem tất cả mã lỗi Xerox Phaser 7760

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie