Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 001-306 — Xerox Phaser 7760

Code: 001-306

Description: Duplex Door Duplex Door (Door D) is open.
Remedy: Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Open the Duplex Transport. Actuate Duplex Cover Interlock Switch with a screwdriver. The display changes. Y↓N→Deactuate the Duplex Cover Interlock Switch. Check voltage on the Drawer Connector between P/J626-6 (+) and GND(-) ( Duplex Transport Assembly, Plug/Jack Locations ). +5 VDC is measured. Y↓N→Check voltage between P/J539-B6 ( I/F PWB, MAIN Motor, LVPS T11- Plug/Jack Locations ) on the I/F PWB and GND(-). +5 VDC is measured. Y↓N→Replace the I/F PWB (PL 13.1). Check for an open circuit between P/J539-B6 on the I/F PWB and Drawer Connector J626-6. Check the wires between Drawer Connector between J626-6 ( Inverter Transport Assembly, Plug/Jack Locations ) and Duplex PWB P/J540-1 ( Duplex Transport Assembly, Plug/Jack Locations ). If the wires are good, replace the Duplex Cover Interlock Switch. Check the Cover Actuator and Cover installation. If there is no problem, replace the Engine Control Board (MCU PWB) (PL 13.1).

← Xem tất cả mã lỗi Xerox Phaser 7760

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie