Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 004-345, 004-561 — Xerox Phaser 7760

Code: 004-345, 004-561

Description: MCU/HVPS Communication Fail Communication error between the Engine Control Board (MCU PWB) and HVPS Control PWB.
Remedy: 1 Is there +5 VDC from P/J 574-5 to P/J 574- 4 on the HVPS Control PWB? Go to step 5. Go to step 2. 2 Disconnect P/J 574. Is there +5 VDC from J 574-5 to J 574-4? Go to step 4. Go to step 3. 3 Is there +5 VDC from P/J 411-5 to ground? Check for open circuit or loose connections in the 5 VDC supply wires between P/J411, pins 5 and 6; and P/ J574, pins 5 and 4. Go to +5 VDC Low- Voltage Power Supplies RAP. 4 Check the wire from J411-5 to J574-5 for a short circuit to GND. Is the wire OK? Replace the HVPS Control PWB. Repair the wiring harness. 5 Switch off the power. and check these wires for an open or short circuit to GND: • HVPS Control PWB P/J574-9 to MCU PWB P/J411-1 • HVPS Control PWB P/J574-8 to MCU PWB P/J411-2 • HVPS Control PWB P/J574-7 to MCU PWB P/J411-3 • HVPS Control PWB P/J574-6 to MCU PWB P/J411-4 Is the wiring OK? Replace the Engine Control Board (MCU PWB). If this does not resolve the problem, replace the HVPS Control PWB. Repair the wiring harness.

← Xem tất cả mã lỗi Xerox Phaser 7760

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie