Description: K Imaging Unit Motor Fail Imaging Unit Motor K failure.
Remedy: 1 1. Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Run the Black Imaging Motor test. 2. Does the Motor operate correctly? Go to step 7. Go to step 2. 2 Is the voltage at J535-6 +5 VDC? Go to step 3. Refer to BSD 8.2 Paper Transportation) to troubleshoot the missing + 5 VDC . 3 Is the voltage at J535-10 +24 VDC? Go to step 4. Refer to BSD 8.2 Paper Transportation) to troubleshoot the missing + 5 VDC . 4 Perform the Black Imaging Unit Motor test. Is the voltage at J535-5 0 VDC with the test running? Go to step 5. Refer to BSD 8.2 Paper Transportation) to troubleshoot . 5 Is the frequency between J535-8 and ground between 1 KHz and 1.3 KHz? Replace the Black Imaging Unit Drive Motor. Go to step 6. 6 Is the frequency between J535-2 and ground between 1KHz and 1.3 KHz? Check for an open circuit between J534A-8 and J535- 8. Replace in order until resolved: 1. Engine Interface Board 2. Engine Control Board (MCU PWB) 7 Is +3.3 VDC present at J535-7 with the Motor test running from Service Diagnostics? Is there is no mechanical blind in the Black Imaging Unit, replace the Black Drum Drive Motor. Refer to - BSD 8.2 Paper Transportation) to troubleshoot the missing +3.3 VDC .