Remedy: BSD: CH9.19 CH9.31A Check if actuator for IBT Edge Sensor touches belt edge. IBT Edge Sensor touches belt edge. Y↓N→Check actuator installation. Turn the printer power On. Measure voltage between I/F PWB P539-A3(+) and GND(-). Between +3 VDC and 1 VDC is measured. Y↓N→Measure voltage between I/F PWB P539-A1(+) P539-A2(-). +5 VDC is measured. Y↓N→Check +5 VDC circuit to I/F PWB P539-A1. Measure voltage between I/F PWB P539-A3(+) and GND(-). +5 VDC is measured. Y↓N→Measure voltage between I/F PWB P539-A3(+) and GND(-). 0 VDC is measured. Y↓N→Check wire damage or bad connection between I/F PWB P539A and IBT Edge Sensor J119. If the check is good, replace IBT Edge Sensor. If the problem continues, replace the Engine Control Board (MCU PWB) (PL 13.1). Check wire damage or bad connection between I/F PWB P539-A3 and IBT Edge Sensor J119-2. Replace IBT Edge Sensor. Measure voltage between I/F PWB P539-A1(+) and GND(-). +24 VDC is measured. Y↓N→Following Wire Network, check +24 VDC circuit up to I/F PWB P539-A1. Remove IBT Assembly. Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Perform the Steering Motor test. IBT Steering Motor energizes. Y↓N→Check wire damage or bad connection between I/F PWB J537 and IBT Steering Motor P207. There are broken wires or bad connections. Y↓N→Replace the Engine Control Board (MCU PWB) (PL 13.1). If the problem continues, replace I/F PWB (PL 9.1). If the problem continues, replace IBT Steering Motor (PL 1.3). Repair broken wire and bad connection. Check IBT Belt installation. If the check is good, replace the Engine Control Board (MCU PWB) (PL 13.1).