Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 007-104 — Xerox Phaser 7760

Code: 007-104

Description: Tray 2 Feed Out Sensor On Jam The Tray 2 Feed Out Sensor does not detect paper fed from Tray 3, 4, or 5 in time after the Takeaway Sensor actuated.
Remedy: Open the Left Lower Cover (PL 2.3). Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Block and unblock Tray 2 Feed Out Sensor (PL 2.3). The display changes. Y↓N→Check the circuit of the Tray 2 Feed Out Sensor. Refer to Transmissive Sensor Procedure for troubleshooting procedure. Close the Left Lower Cover and open the Left Cover and cheat the Left Cover Interlock Switch (PL 16.13). Block and unblock the Takeaway Sensor (PL 16.6). The display changes. Y↓N→Check the circuit of the Takeaway Sensor. Refer to Transmissive Sensor Procedure for troubleshooting procedure. Perform the Tray Feed Sensors test. Both Takeaway Rolls (PL 16.6) rotate. Y↓N→Takeaway Motor 1 energizes. Y↓N→Check the circuit of the Takeaway Motor 1. Refer to OF 99-9 RAP for troubleshooting procedure. Check Takeaway Motor 1 and its associated Gears (PL 16.15) for damage, contamination or misalignment. Repair or replace as required.. • Ensure that the Chutes (PL 2.3, PL 16.5, PL 16.6) are properly seated and not damaged. • Check the Pinch Rolls (PL 2.3, PL 16.13) for damage or contamination. • Ensure that the connectors shown in the circuit diagrams ( ) are securely connected and that the wires are not damaged. • If the problem persists, replace the Tray Module PWB (PL 16.15).

← Xem tất cả mã lỗi Xerox Phaser 7760

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie