Description: Tray 2 Misfeed The Tray 2 Feed Out Sensor does not detect paper after feeding from Tray 2.
Remedy: Open the Left Lower Cover (PL 2.3). Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Block and unblock the Tray 2 Feed Out Sensor (PL 2.3). The display changes. Y↓N→Check the circuit of the Tray 2 Feed Out Sensor. Refer to Transmissive Sensor Procedure for troubleshooting procedure. Close the Left Lower Cover. Perform the Paper Feed Motors test. The Tray 2 Feed/Lift Motor (PL 2.4) energizes. Y↓N→Check the circuit of the Tray 2 Feed/Lift Motor. Refer to OF 99-9 RAP for troubleshooting procedure. • Check the Tray 2 Feed / Lift Motor and its associated gears (PL 2.4) for damage, contamination or misalignment. • Ensure that the Tray 2 Chute (PL 2.3) is properly seated and not damaged. • Ensure that the connectors shown in the circuit diagrams ( ) are securely connected and that the wires are not damaged. • If these checks are OK, replace the I/F PWB (PL 9.1). • If the problem persists, replace the Engine Control Board (MCU PWB) (PL 13.1).