Description: Tray 3 Misfeed The Takeaway Sensor does not detect paper after feeding from Tray 3.
Remedy: Open the Left Cover and cheat the Left Cover Interlock Switch (PL 16.13 - TTM or PL 15.10 - 3TM). Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Block and unblock the Takeaway Sensor (PL 16.6- TTM or PL 15.10 - 3TM). The display changes. Y↓N→Check the circuit of the Takeaway Sensor. Refer to Transmissive Sensor Procedure for troubleshooting procedure. Perform the Paper Feed Motors test. Both Takeaway Rolls (PL 16.6 - TTM or PL 15.10 - 3TM) rotate. Y↓N→Takeaway Motor 1 energizes. Y↓N→+24 VDC is measured between P/J542-10 and GND on the Tray Module PWB (refer to TT Module (rear) Plug/Jack Locations , or 3T Module (rear) Plug/Jack Locations ). Y↓N→+24 VDC is measured at P/J668-3 on the Tray Module PWB (refer to TT Module (rear) Plug/Jack Locations ). Y↓N→Refer to the +24 VDC Wirenets. Check the +24 VDC to the Tray Module PWB. Replace the Tray Module PWB (PL 16.15 - TTM or PL 15.9 - 3TM). +24 VDC is measured at each of the following pins on P/J542: Pins 1, 2, 5, and 6. Y↓N→Refer to . Check the wires from the Tray Module PWB to the Takeaway Motor 1 for an open circuit. If the wires are good, replace the Takeaway Motor 1 (PL 15.9) Check that the voltage at P/J542 pins 1, 2, 5, and 6 each drop to approximately +22 VDC. The voltage at P/J542 pins 1, 2, 5, and 6 all drop to approximately +22 VDC when [008-036] is entered. Y↓N→Replace the Tray Module PWB (PL 16.15 - TTM or PL 15.9 - 3TM). Replace the Takeaway Motor 1 (PL 16.15 - TTM or PL 15.9 - 3TM). Check the Takeaway Motor 1 (PL 16.15 - TTM or PL 15.9 - 3TM) and its associated gears for damage, contamination and misalignment. The Tray 3 Feed/Lift Motor energizes. Y↓N→Check the circuit of the Tray 3 Feed/Lift Motor. Refer to the OF 99-9 RAP for troubleshooting procedure. • Check the Tray 3 Feed / Lift Motor and its associated gears (PL 2.4) for damage and misalignment. • Ensure that the Tray 3 Chute (PL 16.6) is properly seated and not damaged. • Ensure that the connectors shown in the circuit diagrams ( ) are securely connected and that the wires are not damaged. • If these checks are OK, replace the Tray Module PWB (PL 16.15 - TTM or PL 15.9 - 3TM).