Description: Tray 5 Misfeed (TTM) The Tray 5 Feed Out Sensor does not detect paper after feeding from Tray 5.
Remedy: Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Block and unblock the Tray 5 Feed Out Sensor (PL 16.5) by sliding Tray 5 in and out of the machine. The display changes. Y↓N→Check the circuit of the Tray 5 Feed Out Sensor. Refer to Reflective Sensor Procedure for troubleshooting procedure. Perform the Paper Feed Motors test. The Tray 5 Feed/Lift motor energizes (PL 2.4). Y↓N→Check the circuit of the Tray 5 Feed/Lift Motor. Refer to OF 99-9 RAP for troubleshooting procedure. Remove the TTM Rear Cover. Perform Service Diagnostics. The Takeaway Motor 2 (PL 16.15) energizes. Y↓N→Check the circuit of the Takeaway Motor 2. Refer to OF 99-9 RAP for troubleshooting procedure. • Check the Tray 5 Feed / Lift Motor and its associated gears (PL 2.4) for damage, contamination and misalignment. • Check the Takeaway Motor 2 and its associated gears (PL 16.15) for damage, contamination and misalignment. • Check that the Tray 5 Upper and Lower Chutes (PL 16.5) are properly seated and not damaged. • Ensure that the connectors shown in the circuit diagrams ( ) are securely connected and that the wires are not damaged. • If these checks are OK, replace the Tray Module PWB (PL 16.15).