Description: Tray 5 Misfeed (3TM) The Tray 5 Feed Out Sensor does not detect paper after feeding from Tray 5.
Remedy: Open the Left Cover and cheat the Left Cover Interlock Switch (PL 15.10). Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Block and unblock the Tray 5 Feed Out Sensor (PL 15.10). The display changes. Y↓N→Check the circuit of the Tray 5 Feed Out Sensor. Refer to Transmissive Sensor Procedure for troubleshooting procedure. Perform the Paper Feed Motors test. The Tray 5 Feed/Lift Motor (PL 2.4) energizes. Y↓N→Check the circuit of the Tray 5 Feed/Lift Motor. Refer to OF 99-9 RAP for troubleshooting procedure. Perform Service Diagnostics. All 3 Takeaway Rolls (PL 15.10) rotates. Y↓N→Takeaway Motor 1 (PL 15.9) energizes. Y↓N→Check the circuit of the Takeaway Motor 1. Refer to OF 99-9 RAP for troubleshooting procedure. Check the Takeaway Motor 1 and its associated gears (PL 15.9) for damage, contamination, or misalignment. • Check the Tray 5 Feed/Lift Motor and its associated gears (PL 2.4) for damage, contamination, or misalignment. • Ensure that the Tray 5 Chute (PL 15.10) is properly seated and not damaged. • Ensure that the connectors shown in the circuit diagrams ( ) are securely connected and that wires are not damaged. • If these checks are OK, replace the Tray Module PWB (PL 15.9).