Description: Tray 3 Paper Size Sensor Broken An abnormal A/D value was detected by the Tray 3 Paper Size Sensor.
Remedy: Ensure Tray 3 is closed. The voltage measured at P/J546-9 (refer to TT Module (rear) - 3T Module (rear) - Plug/Jack Locations ) - on the Tray Module PWB (PL 16.15) corresponds to the paper size in Table 1. Y↓N→There is +5 VDC from P/J816-1 to P/J816-3 on the Tray 2 Size Sensor (refer to TT Module (Tray 2,3,4, Paper Size Switch) - Plug/Jack Locations ). Y↓N→There is +5 VDC from P/J546-9 to P/J546-7 (refer to TT Module (rear) Plug/Jack Locations or 3T Module (rear) - Plug/Jack Locations ) on the Tray Module PWB. Y↓N→Go to the +5 VDC Wirenets ( +5 VDC Wirenet ) to troubleshoot the power circuit. Check the wires from P/J546 to P/J816. Check the wire from P/J546-9 to P/J816-1. If the wire is OK, replace the Tray 3 Paper Size Sensor (PL 16.1). Replace the Tray Module PWB (PL 16.15 - TTM or PL 15.9 - 3TM). If the problem continues, replace the Tray 3 Paper Size Sensor (PL 16.1).