Description: Tray 4 Paper Size Sensor Broken (3TM) An abnormal A/D value was detected by the Tray 4 Paper Size Sensor.
Remedy: Ensure Tray 4 is properly closed. Measure the voltage at P/J548-11 on the Tray Module PWB (PL 15.9). The voltage measured corresponds with the paper size in Table 1. Y↓N→There is +5 VDC between P/J820-1 and 3 (refer to TT Module (Tray 2,3,4, Paper Size Switch) - Plug/Jack Locations ) on the Paper Size Sensor (PL 16.1). Y↓N→There is +5 VDC between P/J548-12 and 10 on the Tray Module PWB. Y↓N→Go to the +5 VDC Wirenets ( +5 VDC Wirenet ) to troubleshoot the power circuit. Check the wires from P/J548 to P/J820 for damage. Repair or replace as required. Check the wire from P/J548-11 to P/J820-2 for damage. Repair or replace as required. If the wire check out OK, replace the Tray 4 Paper Size Sensor (PL 16.1). • Ensure that the connectors shown in the circuit diagram are securely connected and that the wires are not damaged. • Replace the Tray 4 Paper Size Sensor (PL 16.1). • If the problem persists, replace the Tray Module PWB (PL 15.9).