Description: Tray 5 Paper Size Sensor Broken (3TM) An abnormal A/D value was detected by the Tray5 Paper Size Sensor.
Remedy: Ensure Tray 5 is properly closed. Measure the voltage at P/J548-5 (refer to 3T Module (rear) Plug/Jack Locations ) on the Tray Module PWB (PL 15.9). The voltage measured corresponds with the paper size in Table 1. Y↓N→There is +5 VDC between P/J824-1 and 3 on the Paper Size Sensor (PL 16.1). Y↓N→There is +5 VDC between P/J548-6 and 4 on the Tray Module PWB. Y↓N→Go to the +5 VDC Wirenets ( +5 VDC Wirenet ) to troubleshoot the power circuit. Check the wires from P/J548 to P/J824 for damage. Repair or replace as required. Check the wire from P/J548-5 to P/J824-2 for damage. Repair or replace as required. If the wire check out OK, replace the Tray 5 Paper Size Sensor (PL 16.1). • Ensure that the connectors shown in the circuit diagram are securely connected and that the wires are not damaged. • Replace the Tray 5 Paper Size Sensor (PL 16.1). • If the problem persists, replace the Tray Module PWB (PL 15.9).