Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 007-284 — Xerox Phaser 7760

Code: 007-284

Description: Tray 5 Lift Fail The Tray 5 Level Sensor does not detect that the Tray has lifted. Examine the trays and paper feed assemblies for any physical damage before starting the troubleshooting procedure.
Remedy: 1 Is the problem with Tray 5? Go to step 2. Go to step 7. 2 1. Remove and then reseat Tray 5. 2. Does the Lift Motor operate? Go to step 3. Go to step 4. 3 Did the error clear from the Control Panel? Complete. This could be an intermittent problem. If the problem returns, replace in order: 1. Tray Level Sensor 2. Engine Control Board (MCU PWB) Replace the Engine Control Board (MCU PWB). 4 1. Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Run Tray 5 Sensor test: Tray Sensors > Tray5. 2. Does the level indicate H? Replace in order until resolved: 1. Tray Level Sensor 2. No Paper Sensor 3. Engine Interface Board 4. Engine Control Board (MCU PWB) Go to step 5. 5 1. While still in Service Diagnostics, remove Tray 5. 2. Does SW1-4 indicate LLLL? Replace in order until resolved: 1. Paper-Select Switch Assembly 2. Engine Interface Board 3. Engine Control Board (MCU PWB) Go to step 6. 6 1. Reseat the Paper Tray. 2. Does SW1-4: indicate H in any position? Replace the Paper Feed Motor. Replace in order until resolved: 1. Paper-Select Switch Assembly 2. Engine Interface Board 3. Engine Control Board (MCU PWB) 7 1. Remove and then reseat the problem tray. 2. Listen for the Motor, does the Lift Motor operate? Go to step 8. Go to step 9. 8 Did the error clear from the Control Panel? Complete. This could be an intermittent problem. If the problem returns, replace in order: 1. Tray Level Sensor 2. Engine Control Board (MCU PWB) Replace the Engine Control Board (MCU PWB). 9 Using Service Diagnostics, check the Level Sensor and No Paper Sensor. Replace in order until resolved: 1. Tray Level Sensor 2. No Paper Sensor 3. LTA HCF Control Board 4. Engine Interface Board 5. Engine Control Board (MCU PWB) Go to step 10. 10 While still in Service Diagnostics, remove Tray 5. Replace in order until resolved: 1. Paper-Select Switch Assembly 2. Engine Interface Board 3. Engine Control Board (MCU PWB) Go to step 11. 11 1. Reseat the Paper Tray. 2. Does SW1-4 indicate H in any position? Replace the Paper Feed Motor. Replace in order until resolved: 1. Paper-Select Switch Assembly 2. Engine Interface Board 3. Engine Control Board (MCU PWB)

← Xem tất cả mã lỗi Xerox Phaser 7760

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie