Description: Tray 4 Lift Fail (TTM) Tray 4 Level Sensor does not detect Tray Lift.
Remedy: Enter Service Diagnostics Menu: Print Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Perform the Paper Lift Motor test. The Tray 4 Feed/Lift Motor (PL 2.4) energizes. Y↓N→Check the circuit of the Tray 4 Feed/Lift Motor. Refer to OF 99-9 RAP for troubleshooting procedure. Open and close Tray 4. The display changes. Y↓N→Check the circuit of the Tray 4 Level Sensor. Refer to Transmissive Sensor Procedure for troubleshooting procedure. • Check the Tray 4 Feed/Lift Motor and its associated gears (PL 2.4) for damage, contamination or misalignment. • Check the Tray 4 Tray Cables, Pulleys, and associated gears (PL 16.5) for damage, contamination or misalignment. • Ensure that the connectors show in the circuit diagrams ( ) are securely connected and that the wires are not damaged. • Replace the Tray 4 Level Sensor (PL 2.4). • If these checks ar e OK, replace the Tray Module PWB (PL 16.15).