Description: Tray 5 Lift (TTM) The Tray 5 Level Sensor does not detect Tray Lift.
Remedy: Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Perform the Paper Lift Motor test. The Tray 5 Feed/Lift Motor (PL 2.4) energizes. Y↓N→Check the circuit of the Tray 5 Feed/Lift Motor. Refer to OF 99-9 RAP for troubleshooting procedure. Open and close Tray 5. The display changes. Y↓N→Check the circuit of the Tray 5 Level Sensor. Refer to Transmissive Sensor Procedure for troubleshooting procedure. • Check the Tray 5 Feed / Lift Motor and its associated gears (PL 2.4) for damage, contamination or misalignment. • Check the Tray 5 Tray Cables, Pulleys and associated gears (PL 16.5) for damage, contamination or misalignment. • Ensure that the connectors shown in the circuit diagrams ( ) are securely connected and that the wires are not damaged. • Replace the Tray 5 Level Sensor (PL 2.4). • If these checks are OK, replace the Tray Module PWB (PL 16.15).