Description: Tray 5 Takeaway Sensor On Jam The Takeaway Sensor does not detect paper fed from Tray 5.
Remedy: Open the Left Cover and cheat the Left Cover Interlock Switch (PL 16.13). Enter Service Diagnostics Menu: Printer Menu > Troubleshooting > Service Tools > Printer Status Page > hold the Up and Down buttons simultaneously > Run Service Diagnostics > OK. Block and unblock the Takeaway Sensor (PL 16.6). The display changes state. Y↓N→Check the circuit of the Takeaway Sensor. Refer to Transmissive Sensor Procedure for troubleshooting procedure. Perform Service Diagnostics. Both Takeaway Rolls (PL 16.6) rotate. Y↓N→Takeaway Motor 1 (PL 16.15) energizes. Y↓N→Check the circuit of the Takeaway Motor 1. Refer to OF 99-9 RAP for troubleshooting procedure. Check the Takeaway Motor 1 and its associated gears (PL 16.15) for damage, contamination and misalignment. Remove the TTM Rear Cover. Perform Service Diagnostics. The Takeaway Motor 2 (PL 16.15) energizes. Y↓N→Check the circuit of the Takeaway Motor 2. Refer to the OF 99-9 RAP for troubleshooting procedure. • Check the Takeaway Motor 2 and its associated gears (PL 16.15) for damage, contamination and misalignment. • Ensure that the Chutes (PL 16.6) are properly seated and not damaged. • Ensure that the connectors shown in the circuit diagrams ( ) are securely connected and that the wires are not damaged. • Replace the Takeaway Sensor (PL 16.6). • If the problem persists, replace the Tray Module PWB (PL 16.15).